MP-1xx/H.323 User’s Manual
2. MP-10x Hardware Installation
Version 4.2 Beta
19
June 2003
2.1.4 Cable
Connections
The RJ-45 (Ethernet) and RJ-11 (Ports) pinouts and connectors are shown in Figure 2-3, and
pins are numbered from the left with the latching finger position at the bottom.
Figure 2-3: RJ-45 LAN and RJ-11 Port Connectors and Pinouts
1 2 3 4
1 -
2 -
3 -
4 -
Not connected
RJ-11 Connector and Pinout
Not connected
Tip
Ring
1 2 3 4 5 6 7 8
RJ-45 Connector and Pinout
4, 5, 7, 8
not
connected
1 - Tx+
2 - Tx-
3 - Rx+
6 - Rx-
$
To connect the cables for Desk-top or Rack-mount go to Step 4 below:
Step 4
When
using
MP-10x/FXS
Gateway, insert each of the RJ-11 connectors on the 2-wire
line cords of the POTS phones into the RJ-11 sockets on the rear of the Gateway.
When using
MP-10x/FXO
Gateway, insert each of the RJ-11 connectors on the 2-wire
line cords coming from PSTN/PBX into the RJ-11 sockets on the rear of the Gateway
Telephone lines and extensions of up to 7,300 m (24,000 ft) can be achieved using
regular 24 AWG line cord.
Step 5
Insert the RJ-45 connector on the 10/100 Base-T cable from your LAN to the ETH RJ-
45 socket (on the rear of the
MP-10x
) to provide the link to your LAN.
Step 6
Connect
the
MP-10x
Gateway to the correct AC power supply, and the installation is
now complete.
2.1.5
Installation of the MP-10x/FXS Life Line
Note
: The
MP-124 and MP-10x/FXO
Media Gateways do
NOT
support the Life Line.
The
MP-108/FXS and MP-104/FXS
Gateways
provide a Life Line connection on port
#4
.
The
MP-102/FXS
Gateway provides a Life Line connection on port
#2
.
This feature provides a wired phone connection to any PSTN or PBX FXS port, upon power-down
conditions. When the power outage occurs, the phone that is connected to the Life Line port (see
above), on pins #2 and #3, is wired to the PSTN or PBX FXS wires on pins #1 and #4 on the
same connector. Therefore, the User of the
MP-10x/FXS
, can use the phone even when the
MP-
10x/FXS
is not powered-on. To use this function, the User must utilize a splitter that connects
pins #1 and #4 to another source of an FXS port, and pins #2 and #3 to the POTS phone.
The pinout of the Life Line RJ-11 phone connector is as follows:
1 = Life Line TIP
2 = TIP
3 = RING
4 = Life Line RING
Refer to Figure 2-4 below for the RJ-11 connector pinout.
Figure 2-4: RJ-11 Connector and Life Line Pinout for MP-10x/FXS
1 2 3 4
1 -
2 -
3 -
4 -
Life Line Tip
RJ-11 Connector and Life Line Pinout
Life Line Ring
Tip
Ring
Summary of Contents for MediaPack MP-102
Page 2: ......
