AudioCodes Mediant MSBR, Configuration Note, Page: 7 / 38

Version 7.2 7 Mediant MSBR
Configuration Note 1. Introduction
1 Introduction
This document describes the following important information for MSBR users when
upgrading to Version 7.2:

CLI Changes: Most of the changes to the CLI affect the Voice configuration. Only a
few of the CLI changes affect the Data configuration. These changes are described in
this document.

Old CLI Script: "show running-config" output that has been copied from Version 6.8
can be inserted into 7.2. Also commands copied from Version 6.8 will work if inserted
using the full command text string. For Example: "show" will work, and "sh …" will not
work.

Autocomplete: Entering CLI commands using autocomplete i.e. using the tab key,
will not work for existing Version 6.8 commands whose path has been changed in
Version 7.2 (as shown in Section
4.2).

Dual Network Mode: When upgrade is performed from Version 6.8 to Version 7.2
and the existing Version 6.8 platform is configured to work in Dual Network mode, the
Dual Network mode configuration remains. New MSBR devices with a clean
installation of Version 7.2 are by default configured with a Single Network mode.
In addition to the above, this document also includes instructions on how to upgrade device
firmware to Version 7.2 and also includes example configuration output for both Version
6.8 and Version 7.2.