Version 6.6
763
October 2014
Installation & Operation Manual
43. Session Border Controller (SBC) Application
43.13.1
Configuring the SBC Message Manipulation Table
The manipulation is performed on SIP messages according to the Classification table
(source/destination of username/host prefixes and source IP address). The
manipulation can be performed on message type (Method, Request/Response, and
Response type). Message manipulations are performed only after the classification,
inbound manipulations and routing are successfully performed (i.e., manipulations are
performed only in the outgoing leg).
SIP Message manipulation rules can be assigned to an IP Group in the IP Group table
and it can be determined whether they must be performed for inbound or outbound
messages.
To configure SBC Message Manipulation:
1.
Click the
button to access the Media Gateway status screen.
2.
Select the SIP board.
3.
In the Navigation
pane, select
SIP
SBC
SBC Message Manipulation
; the
SBC Message Manipulation list is displayed.
4.
Use the
or
buttons to add or remove entries.
5.
Select a specific row and in the Configuration pane, click
SBC Message
Manipulation
; the SIP SBC
Message Manipulation screen is displayed.
6.
Configure SIP SBC
Message Manipulation parameters according to the table SIP
SBC
Message Manipulation Table Matching Rules' below.
7.
Click the Maintenance icon
and select
Unlock
to activate the configuration.
Table
43-13: SIP SBC Message Manipulation Table
Parameter Name
Type
Provisioning
Type
Description
Manipulation Set
ID
Integer
0-19
Instant
Unique manipulation set ID that you can
later assign to an IP Group.
Message Type
String
Up to 50 chars
Instant
SIP message type that you want to
manipulate.The valid value is a string
depicting the SIP message
Condition
String
Up to 200 chars
Instant
Condition that must exist for the rule to
apply.
Action Subject
String
Up to 100 chars
Instant
SIP header upon which the manipulation is
performed.
Summary of Contents for Mediant 8000
