AudioCodes Mediant 500 E-SBC, User Manual

Page: 695 / 920

User's Manual 54. Configuration Parameters Reference
Version 6.8 695 Mediant 500 E-SBC
54.1.3 Telnet Parameters
The Telnet parameters are described in the table below.
Table 54-3: Telnet Parameters
Parameter Description
Web: Embedded Telnet Server
EMS: Server Enable
CLI: telnet
[TelnetServerEnable]
Enables the device's embedded Telnet server. Telnet is disabled by
default for security.

[0] Disable

[1] Enable Unsecured (default)

[2] Enable Secured
Note: Only the primary Web User Account (which has Security
Administration access level) can access the device using Telnet
(see ''Configuring Web User Accounts'' on page
54 ).
Web: Telnet Server TCP Port
EMS: Server Port
CLI: telnet-port
[TelnetServerPort]
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is 23.
Web: Telnet Server Idle
Timeout
EMS: Server Idle Disconnect
CLI: idle-timeout
[TelnetServerIdleDisconnect]
Defines the timeout (in minutes) for disconnection of an idle Telnet
session. When set to zero, idle sessions are not disconnected.
The valid range is any value. The default is 0.
Note: For this parameter to take effect, a device reset is required.
Web: Maximum Telnet
Sessions
CLI: telnet-max-sessions
[TelnetMaxSessions]
Defines the maximum number of permitted, concurrent Telnet/SSH
sessions.
The valid range is 1 to 5 sessions. The default is 2.
Note: Before changing the value, make sure that not more than this
number of sessions are currently active; otherwise, the new setting
will not take effect.
[CLIPrivPass]
Defines the password to access the Enable configuration mode in
the CLI.
The valid value is a string of up to 50 characters. The default is
"Admin".
Notes:

The password is case-sensitive.

The password is required only by Admin and Monitor user
access levels; Security Administrator and Master user access
levels automatically enter the Enable mode upon initial login.