AudioCodes Mediant 500 E-SBC, User Manual

Page: 684 / 920

User's Manual 684 Document #: LTRT-10437
Mediant 500 E-SBC

To configure SBC call testing:
1. Configure the test call parameters (for a full description, see ''SIP Test Call
Parameters'' on page
716 ):
a. Open the Test Call Settings page ( Configuration tab > System menu > Test
Call > Test Call Settings ).
Figure 52-7: Test Call Settings Page
b. In the 'Test Call ID' field, enter a prefix number for the simulated test endpoint on
the device.
c. In the 'SBC Test ID' field, enter a called prefix number for identifying the call as
an SBC test call.
d. Click Submit .
2. Configure regular SBC call processing rules for called number prefix "101", such as
classification and IP-to-IP routing through a proxy server.
52.7 Test Call Configuration Examples
Below are a few examples of test call configurations.

Single Test Call Scenario: This example describes the configuration of a simple test
call scenario that includes a single test call between a simulated test endpoint on the
device and a remote endpoint.
Figure 52-8: Single Test Call Example
•
Test Call table configuration:
♦
Endpoint URI: "101"
♦
Called URI: "201"
♦
Route By: Dest Address
♦
Destination Address: "10.30.40.01"
♦
Call Party: Caller
♦
Test Mode: Once
Alternatively, if you want to route the test call using the Outbound IP Routing table for
the Gateway / IP-to-IP application, configure the following:
•
Test Call table configuration:
♦
Endpoint URI: 101@10.0.0.1
♦
Route By: GW Tel2IP
♦
Called URI: 201@10.30.40.1
♦
Call Party: Caller