AudioCodes Mediant 500 E-SBC, User Manual

Page: 597 / 920

User's Manual 41. Restoring Factory Defaults
Version 6.8 597 Mediant 500 E-SBC
41 Restoring Factory Defaults
You can restore the device's configuration to factory defaults using one of the following
methods:

CLI (see ''Restoring Defaults using CLI'' on page 597 )

Hardware reset pinhole button (see Restoring Defaults using Hardware Reset Button
on page
598 )

Loading an empty ini file (see ''Restoring Defaults using an ini File'' on page 598 )
41.1 Restoring Defaults using CLI
The device can be restored to factory defaults using CLI, as described in the procedure
below.

To restore factory defaults using CLI:
1. Access the CLI:
a. Connect the RS-232 serial port of the device to the communication port on your
computer. For serial cabling, refer to the
Hardware Installation Manual .
b. Establish serial communication with the device using a serial communication
program (such as HyperTerminal
TM ) with the following communication port
settings:
♦
Baud Rate: 115,200 bps
♦
Data Bits: 8
♦
Parity: None
♦
Stop Bits: 1
♦
Flow Control: None
2. At the CLI prompt, type the username (default is "Admin" - case sensitive), and then
press Enter:
# Username: Admin
3. At the prompt, type the password (default is "Admin" - case sensitive), and then press
Enter:
# Password: Admin
4. At the prompt, type the following, and then press Enter:
# enable
5. At the prompt, type the password again, and then press Enter:
# Password: Admin
6. At the prompt, type the following to reset the device to default settings, and then press
Enter:
# write factory