AudioCodes Mediant 3000, User Manual

Page: 87 / 872

Version 6.6 87 Mediant 3000
User's Manual 5. CLI-Based Management
B=Broadcast H=Host I=Invalid
End of routing table, 4 entries displayed.
5.4.2 Ping Command
The Ping command is described in the following table:
Table 3: Ping Command
Command Short Format Arguments Description
PING ping [-n count]
[-l size]
[-w timeout]
[-p cos]
ip-address
Sends ICMP echo request packets to a
specified IP address.

count: number of packets to send.

size: payload size in each packet.

timeout: time (in seconds) to wait for a reply
to each packet.

cos: Class-of-Service (as per 802.1p) to
use.
Example:
/>ping 10.31.2.10
Ping process started for address 10.31.2.10. Process ID - 27.
Reply from 10.31.2.10: bytes=0 time<0ms
Reply from 10.31.2.10: bytes=0 time<0ms
Reply from 10.31.2.10: bytes=0 time<0ms
Reply from 10.31.2.10: bytes=0 time<0ms
Ping statistics for 10.31.2.10:
Packets:Sent = 4, Received = 4, Lost 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
5.4.3 Test Call (TC) Commands
The Test Call commands can be used to simulate an IP-to-PSTN call.
Note: Only one test call can be activated at a given time.
Table 4: Test Call Command
Command Short Format Sub-Commands
/ SIP / TestCall / sip / tc set dest | set src | set cid | set DTMFs | display | connect
Table 5: Sub-Commands of Test (TC) Command
Sub-Command Arguments Description
set dest <number> Sets the Destination Number for the test call.
The linked image cannot be displayed. The file may have been moved, renamed, or deleted. Verify that the link points to the correct file and location.