AudioCodes Mediant 3000, User Manual

Page: 539 / 872

Version 6.6 539 Mediant 3000
User's Manual 41. Software Upgrade

LocalUser is the user and is used as the Request-URI user part for the AOR in the
database

UserName is the user's authentication username

Password is the user's authentication password

IPGroupID is the IP Group ID to which the user belongs and is used as the Request-
URI source host part for the AOR in the database
Notes:
•
To enable the User Info table, see 'Enabling the User Info Table' on page 539 .
•
To modify the Use Info table, you need to load a new User Info file containing your
modifications.
41.1.5.3 Enabling the User Info Table
The procedure below describes how to load a User Info file to the device and enable the
use of the User Info table:

To enable the User Info table:
1. Open the Advanced Parameters page ( Configuration tab > VoIP menu > SIP
Definitions > Advanced Parameters ).
2. Set the 'Enable User-Information Usage' parameter to Enable .
41.1.6 AMD Sensitivity File
The AMD Sensitivity file allows you to configure the device with different AMD Sensitivity
suites. You can load the device with up to four AMD Sensitivity suites. Each suite can be
configured to a different language, country or region, thereby fine tuning the detection
algorithm of the DSP according to requirements.
The structure of the file can be viewed in the example below. Each file consists of at least
one parameter suite with its suite ID. Each parameter suite consists of up to 16 sensitivity
levels, where each level possessing 3 coefficients A, B and C. When loading a new
parameter suite, the existing parameter suite with the same ID is overwritten.
The file is created in .xml format and installed on the device as a binary file (with a .dat
extension). The XML to binary file format is processed by AudioCodes DConvert utility. For
more information, refer to
DConvert Utility User's Guide .
The file can be installed on the device in the following ways:

TFTP at initialization time, by setting the ini file parameter AMDSensitivityFileName
with the .dat file name, and adding the file to the TFTP directory.

Auxiliary files Web page (see 'Loading Auxiliary Files' on page 525 ).

Using the AutoUpdate mechanism (see 'Automatic Update' on page 553 ). In this case
the AMDSensitivityFileUrl parameter must be set using SNMP or ini file.
The following example shows an xml file with two parameter suites:

Parameter Suite 0 with six sensitivity levels

Parameter Suite 2 with three sensitivity levels
<AMDSENSITIVITY>
<PARAMETERSUIT>
<PARAMETERSUITID>0</PARAMETERSUITID>
<!-- First language/country -->