AudioCodes Mediant 3000, User Manual

Page: 193 / 872

Version 6.6 193 Mediant 3000
User's Manual 13. Media

To configure general media parameters:
1. Open the General Media Settings page ( Configuration tab > VoIP menu > Media
submenu > General Media Settings ).
Figure 13-12: Coder Attribute Configuration in General Media Settings Page
2. Configure the parameters as required, and then click Submit .
3. To save the changes to flash memory, see 'Saving Configuration' on page 520 .
13.6 Configuring DSP Templates
The DSP Template determines the coders that can be used by the device and various
other functionalities. For a list of DSP templates and the maximum number of channels
supported by each coder, see 'DSP Templates' on page
859 . You can select a single DSP
Template or you can select two DSP Templates and define the percentage of DSP
resources allocated per DSP Template. For example, you can assign DSP Template 1 to
50% of the device's DSPs, and DSP Template 2 to the remaining 50%.
Notes:
•
The DSP Templates table must be used only when two concurrent DSP
templates are required. When a single DSP template is required, use the
'DSP Version Template Number' parameter to select the template.
•
If no entries are defined, the device uses the default DSP template (i.e.,
Template 0).
•
A single DSP Template can also be configured using the ini file
parameter, DSPVersionTemplateNumber.
•
The DSP Templates table can also be configured using the table ini file
parameter, DSPTemplates.