AudioCodes Mediant 2000, User Manual

Page: 195 / 418

Version 5.6 195 November 2008
SIP User's Manual 3. Web-Based Management
5.
Configure the IP Profile's parameters according to your requirements. For detailed
information on each parameter, refer to the description on the page in which it is
configured as an individual parameter. Parameters that are unique to IP Profile are
described in the table below.
6.
From the 'Coder Group' drop-down list, select the coder group you want to assign to
the Profile. You can select the device's default coders (refer to ''Coders'' on page
144 )
or one of the coder groups you defined in the 'Coder Group Settings' page (refer to
''Coder Group Settings'' on page
190 ).
7.
Repeat steps 2 through 6 for the next IP Profiles (optional).
8.
Click the
Submit
button to save your changes.
9.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 230 .
Table 3-48: Description of Parameter Unique to IP Profile
Parameter Description
Number of Calls Limit Maximum number of concurrent calls. If the profile is set to some limit, the
device maintains the number of concurrent calls (incoming and outgoing)
pertaining to the specific profile. A limit value of '-1' indicates that there is
no limitation on calls for that specific profile (default). A limit value of '0'
indicates that all calls are rejected. When the number of concurrent calls is
equal to the limit, the device rejects any new incoming and outgoing calls
belonging to that profile.
3.4.7.6 Configuring the Trunk and IP Groups
The Trunk
/IP Group
menu allows you to configure groups of channels. This submenu
includes the following page items:
„ Trunk Group (refer to “Configuring the Trunk Group Table” on page 195 )
„ Trunk Group Settings (refer to ''Configuring the Trunk Group Settings'' on page 197 )
„ IP Group Table (refer to ''Configuring the IP Groups'' on page 201 )
„ Account Table (refer to ''Configuring the Account Table'' on page 204 )
3.4.7.6.1 Configuring the Trunk Group Table
The 'Trunk Group Table' page provides you with a table for enabling device channels, by
assigning them telephone numbers, Trunk Groups, and Profiles. Trunk Groups are used for
routing IP-to-Tel calls with common rules. Channels that are not defined are disabled. You
can add up to 24entries in this table.
Note:
You can also configure the Trunk Groups using the
ini
file table parameter
TrunkGroup_x to (refer to ''Number Manipulation and Routing Parameters'' on
page
313 ).