AudioCodes Mediant 1000B SBA, Installation And Maintenance Manual, Page: 214 / 298

Installation & Maintenance Manual 214 Document #: LTRT-40111
Mediant 1000B SBA
29.9 Defining the SBA Image File Source
You can configure the source (location) from where the image file can be obtained for the
SBA upgrade and recovery process, using the Source parameter:

FTP: Set Source to 1, as shown below:
[ImageSource] Source = 1
If the image file is located on an FTP server, then see Section 29.9.1 on page 214 to
define the FTP server address and login credentials.

Local network: Set Source to 2, as shown below:
[ImageSource] Source = 2
If the image file is located on the local network, then see Section 29.9.2 on page 215
to define the network path (URI) to where the file is located and the logon username
and password.

SBA Recovery USB dongle (recommended and default): Set Source to 3, as shown
below:
[ImageSource] Source = 3
If the image file is located on the USB dongle, then see Section 29.9.3 on page 215 to
define the directory path to where the image file is located.

Recovery partition: Set Source to 4, as shown below:
[ImageSource] Source = 4
If the image file is located on the recovery partition, then see Section 29.9.4 on page
215 to define the directory path to where the file is located.
Note: For sources 1, 2, and 3, the image is also copied to the recovery (second) partition
for future use.
29.9.1 Defining the FTP
If the image file is located on an FTP server (i.e., [ImageSource] Source = 1, as defined in
Section 29.9 on page 214 ), then you need to define the FTP server address and login
credentials:

[FtpSettings] Site: Defines the IP address or FQDN of the FTP server (FTP server
can be in the local network or on the Internet):
[FtpSettings] Site=10.13.4.115

[FtpSettings] User: Defines the FTP login user name:
[FtpSettings] User=Admin

[FtpSettings] Password: Defines the FTP login password:
[FtpSettings] Password=1234
Note: The image file must be located on the root of the FTP server.