AudioCodes Media Pack MP-11x, User Manual

Page: 515 / 650

Version 6.6 515 MP-11x & MP-124
User's Manual 44. Configuration Parameters Reference
44.5 RADIUS Parameters
The RADIUS parameters are described in the table below. For supported RADIUS
attributes, see 'RADIUS Accounting CDR Attributes' on page
435 .
Table 44-29: RADIUS Parameters
Parameter Description
RADIUS Accounting Parameters
Web: Enable RADIUS Access
Control
[EnableRADIUS]
Enables the RADIUS application.

[0] Disable (Default)

[1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: Accounting Server IP
Address
[RADIUSAccServerIP]
Defines the IP address of the RADIUS accounting server.
Web: Accounting Port
[RADIUSAccPort]
Defines the port of the RADIUS accounting server.
The default is 1646.
Web/EMS: RADIUS Accounting
Type
[RADIUSAccountingType]
Determines when the RADIUS accounting messages are sent to
the RADIUS accounting server.

[0] At Call Release = (Default) Sent at call release only.

[1] At Connect & Release = Sent at call connect and release.

[2] At Setup & Release = Sent at call setup and release.
Web: AAA Indications
EMS: Indications
[AAAIndications]
Determines the Authentication, Authorization and Accounting
(AAA) indications.

[0] None = (Default) No indications.

[3] Accounting Only = Only accounting indications are used.
General RADIUS Parameters
Web: Use RADIUS for
Web/Telnet Login
EMS: Web Use Radius Login
[WebRADIUSLogin]
Enables RADIUS queries for Web and Telnet login authentication.
When enabled, logging into the device's Web and Telnet
embedded servers is done through a RADIUS server. The device
communicates with a user-defined RADIUS server and verifies the
given username and password against a remote database, in a
secure manner.

[0] Disable (default)

[1] Enable
Notes:

For RADIUS login authentication to function, you also need to
set the following parameters:

EnableRADIUS = 1 (Enable)

WebAuthMode = 0 (Basic Mode)

RADIUS authentication requires HTTP basic authentication,
where the username and password are transmitted in clear text
over the network. Therefore, it's recommended to set the
HTTPSOnly parameter to 1 in order to force the use of HTTPS,
since the transport is encrypted.

If using RADIUS authentication to log into the CLI, only the
primary Web User Account, which has Security Administration
access level, can access the device's CLI (see 'Configuring