AudioCodes M500Li, Configuration Manual, Page: 8 / 15

1. Getting Started with Initial Connectivity M500Li Analog VoIP Gateway
- 6 -
1.3 Configuring Voice Gateway LAN and WAN
This section describes how to configure the device's LAN and WAN interfaces.
After accessing the device through the LAN interface, you can configure Web management
access from one of the following interfaces:
◼ Any of the configured Voice Gateway LAN interfaces (default LAN interface is
192.168.0.1).
◼
WAN port interface: In this setup, you need to enable remote access to the WAN port
interface, as described in section
1.3.3 , Remote Web-based (HTTP/S) Management
on page 7 .
1.3.1 Modifying the LAN Interface
The device's default LAN IP address is 192.168.0.1/24. You can change this to suit your
networking scheme.
By default, the device's embedded DHCP server is enabled for the LAN, and with default IP
pool addresses relating to the default subnet LAN. You can disable the DHCP server or
modify the IP address pool. The DHCP server allocates this pool of IP addresses to the
computers connected to its LAN interface.
To modify the LAN interface
:
1. Open the LAN Interface page ( Setup menu > IP NETWORK tab > CORE ENTITIES folder > LAN
Interface ).
2. In this page you can set:
•
LAN INTERFACES SETTINGS
•
DHCP SETTINGS (Enable / Disable)
•
DNS SETTINGS