AudioBahn A12001DT, Operating Instructions Manual

Page: 11 / 21

Controls and Functions
��
The remote terminal needs to be wired to the car's stereo or source unit remote turn on wire. This
amplifier is turned on remotely when the vehicle's stereo is turned on.
NOTE: iF YOUR RADIO DOES NOT HAVE A +12 VOLT OUTPUT LEAD WHEN THE CAR IS TURNED
ON, THE "REMOTE" TERMINAL ON THE AMPLIFIER CAN BE CONNECTED TO THE VEHICLE'S
ACCESSORY CIRCUIT THAT IS LIVE WHEN THE KEY IS TURNED ON.
PWR (Power): This BLUE LED will illuminate when the amplifier is turned on. If it fails to illuminate, check
the fuses and power connections to the amplifier.
PROT (Protection): The amplifier protection circuitry will disable the amplifier if there is an imput overload,
short circuit, or extremely high temperature conditions are detected. When the protection mode is in
operation, the LED indicator on the side panel will be illuminated RED, indicating the amplifier has gone
into a self-preservation mode.
If you observe that the protection LED is lit, please check the system carefully to determine what has
caused the protection circuit to engage. The amplifier can be reset by turning the remote power off and
then on again. If the amplifier shut down due to a thermal overload condition, please allow time for the
amp to cool down before restarting. If the amplifier shut down because of an input overload or short
circuit, be sure to repair these conditions before attempting to power up the amplifier again.
14. Remote Turn-on Input
15. LED Indicators