4
V
F
I
Assembly Instructions
PM2-S/D/XL/CS
Mounts
www.video-furn.com
288 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
Check furniture from underside to see if partial cuts are there.
(Partial cut is routing 3/4 way thru bottom side)
If so. Use existing cuts as guide , finish cuts all the way through to top.
If not.
A. Center base at desired location, Approx. 3” from back of plate to back of
furniture. Check inside for hole and bolt clearance or interference.
B. Using Base as guide, drill through base round holes and furniture.
C. Mark slot location and drill with hole saw. (remove Base before drilling)
(Most AVFI furniture is precut or partially cut
to accommodate this mount.)
1
2
3
3
2. Slide Main Pillar into drilled holes
(Make sure top holes are at the back for
camera above TV and holes + grommet at
front for camera below TV)(See Step 9* for
details)
3. Attach Base Washer and secure with Nuts
From underneath.
M10 Nuts (2)
Base washer (1)
4. Insert and center mounting tube
through the Main Pillar.
Tube Length will vary depending on
mount used.
Slide in Tube locker over top and secure
Using M8 Bolts and Allen key.
M8 X 12 (2)
Tube locker
(1)
M8 Hex key
x1
