background image

Model VSi55

VSi55 Manual / 3-03 / 

2-

17

-03

5

Disposal and Recycling Guidelines

To dispose of this electronic product, do not place in land-
fill. In accordance with the European Union Waste Electri-
cal  and  Electronic  Equipment  (WEEE)  directive  effective 
August 2005, this product may contain regulated materials
which  upon  disposal  require  special  reuse  and  recycling
processing.

Limited Warranty

Audio  Research  Corporation  products  are  covered  by  a  3-
Year  Limited  Warranty,  or  a  90-Day  Limited  Warranty 
(vacuum  tubes).  This  Limited  Warranty  initiates  from  the
date of purchase, and is limited to the original purchaser, or
in  the  case  of  demonstration  equipment,  limited  to  the 
balance  of  warranty  remaining  after  original  shipment 
to the retailer or importer.

In  the  United  States,  the  specific  terms,  conditions  and
remedies  for  fulfillment  of  this  Limited  Warranty  are 
listed  on  the  warranty  card  accompanying  the  product  in
its shipping carton, or may be obtained from the authorized
retailer  or  from  the  Audio  Research  Customer  Service 
Department.  Outside  the  United  States,  the  authorized 
importing retailer or distributor has accepted the responsi-
bility  for  warranty  of  Audio  Research  products  sold  by
them.  The  specific  terms  and  remedies  for  fulfillment  of
the  Limited  Warranty  may  vary  from  country  to  country.
Warranty  service  should  normally  be  obtained  from  the 
importing  retailer  or  distributor  from  whom  the  product
was purchased.

In  the  unlikely  event  that  technical  service  beyond  the 
ability  of  the  importer  is  required,  Audio  Research  will 
fulfill  the  terms  and  conditions  of  the  Limited  Warranty.
Such product must be returned at the purchaser's expense
to  the  Audio  Research  factory,  along  with  a  photocopy  of
the  dated  purchase  receipt  for  the  product,  a  written 
description  of  the  problem(s)  encountered,  and  any  infor-
mation  necessary  for  return  shipment.  The  cost  of  return
shipment is the responsibility of the purchaser.

Specifications 

POWER OUTPUT

: 50 watts per channel continuous  from

20Hz to 20kHz. 1 kHz total harmonic distortion typically 1% at
50 watts, below .05% at 1 watt.

Approximate actual power available at “clipping” 52 watts
(1kHz). (Note that actual power output is dependent upon 
both line voltage and “condition” i. e.: if power line has high 
distortion, maximum power will be affected adversely, although
from a listening standpoint this is not very critical.)

POWER BANDWIDTH:

(-3dB points)  12Hz to 90kHz.

FREQUENCY RESPONSE: 

(-3dB points at 1 watt) 

1.0Hz to 100 kHz.

INPUT SENSITIVITY: 

0.5V RMS Single-ended for rated 

output. (32dB gain into 8 ohms.)

INPUT IMPEDANCE:

50K ohms Single-ended. 

INPUTS (5):

CD, Tuner, Video, SE1, SE2 (Single Ended RCA

connectors).

MAXIMUM INPUT:

3.5V RMS (any input). Optional 6dB pad

for CD input. 

OUTPUT POLARITY:

Non-Inverting (any input).

PUSH BUTTONS:

Volume up, Volume down. (70 steps, 20

LED indicators), Input, Mono, Mute, Power. All functions on 
IR remote control.

OUTPUT TAPS

: 8 ohms, 4 ohms.

OUTPUT REGULATION:

Approximately 1.5dB 8 ohm load to

open circuit (Damping factor approximately 5).

MONO SUBWOOFER OUTPUT: 

1V RMS at rated power.

OVERALL NEGATIVE FEEDBACK: 

10dB.

SLEW  RATE:

10 volts/microsecond.

RISE TIME:

2 microseconds.

HUM  & NOISE:

Less than 0.14mV RMS – 103dB below rated

output (IHF weighted, input shorted). 

POWER SUPPLIES:

Electronically regulated Low and 

High voltage supplies for input stages. Automatic 30 sec.
warm-up / brown-out mute.

POWER SUPPLY ENERGY STORAGE:

Approximately 166

joules.

POWER REQUIREMENTS:

100-125VAC 60Hz (200-250VAC

50Hz) 320 watts at rated output, 500 watts maximum, 205
watts at “idle”. 0.5 watts power off.

TUBES REQUIRED: 

2 – Matched pair 6550EH – Power 

Output; 3 – 6N1P input and driver.

DIMENSIONS : 

14" (35.6 cm) W x 8" (20.3 cm) H x 16" 

(40.6 cm) D. Rear connectors extend .88" beyond chassis.

WEIGHT:

34 lbs. (15.5 kg) Net; 40 lbs. ( 18.2 kg )  Shipping.

Specifications subject  to change without notice.

©2003 Audio Research Corporation.

Summary of Contents for VSi55









Reviews: