Operation
After all the necessary connection cables are in place, you are ready to switch on the RHEA II and
your amplifier. Set the power switch to position "ON", as previously described.
When the RHEA II is on, the indicator light on the rear side of the subwoofer will glow red.
If you press the multifunction switch (2.9) on the front side of the subwoofer, the display (2.8) will
illuminate.
In order to switch the RHEA II back to the standby mode, press on the multifunction switch for about 3
seconds. When you set the power switch at the rear of the subwoofer to the “OFF” position, the power
supply is completely cut off from the AC line.
Volume Adjustment
RHEA II:
Use the multifunction switch to
adjust the volume until ideal
blending between the subwoofer
output and the loudspeaker level is
obtained.
Turn
the
switch
clockwise to increase the volume,
or anti-clockwise to decrease the
volume. The volume of your RHEA
II can be adjusted in 1dB steps
between 0 dB and 31 dB, and in
2db steps between 31 dB and 79
dB.
Remote Control:
Use the [VOL+] and [VOL-] buttons
to adjust the volume until ideal
blending between the subwoofer
output and the loudspeaker level is
obtained. The volume of your
RHEA II can be adjusted in 1dB
steps between 0 dB and 31 dB,
and in 2 db steps between 31 dB
and 79 dB.
Crossover Frequency Adjustment
RHEA II:
In order to adjust the subwoofer’s
crossover
frequency,
keep
pressing the multifunction switch
until the words “Crossover Freq.”
appear in the display.
Set
the
desired
crossover
frequency (40Hz, 50Hz, 63Hz,
80Hz, 100Hz or 125Hz) by turning
the multifunction switch and press
the switch again to confirm your
setting. The confirmed setting
appears in the display where the
frequency is indicated by a "*".
Remote Control:
Use the [FR] and
[FREQUENCY-] buttons to adjust
the
subwoofer’s
crossover
frequency.
You are able to set the desired
crossover frequency to 40Hz,
50Hz, 63Hz, 80Hz, 100Hz or
125Hz.
