Unpacking and Assembly – The CLASSIC 10 | CLASSIC 20 | CLASSIC 30
1.
Place the boxes on the floor, making sure that the product labels are facing up, and carefully open the
packaging on the long side where it has been taped up, preferably using a pocket knife or kitchen knife
(similar to illustrations).
2.
Remove the “Welcome to the Audio Physic“ package and the accessories.
3.
Keep the box on the floor and carefully remove the loudspeaker together with its protective foam pads. It
is ideal if two people carry out this step. Make sure that you
do not touch the drivers
when removing and
handling the loudspeaker as this may cause irreparable damage to the drivers.
4.
Now remove the top foam cover and carefully slide down the protective foil so that you can easily attach the
spikes that come with the loudspeaker.
5.
Tighten the lock nuts onto the spikes.
6.
Now turn over the loudspeakers so that the loudspeakers are in stable contact with the floor.
Two people
should also carry out this step where possible.
Make sure that you do not hurt yourself on the tips of the spikes.
7.
Place the loudspeakers in their intended positions and finely adjust the spikes so that the
loudspeakers do not wobble. If you do not place the loudspeakers in a secure and stable
position and they therefore wobble, this will have a major effect on the sound. When the
boxes are standing level and upright, you have set them up perfectly. The enclosed spirit level
will help you to finely adjust the loudspeakers (they are level when the bubble remains in the
inner circle). Now use the lock nuts to again tighten the spikes. Roughly hand-tightening the
nuts is sufficient.
8.
Our CLASSIC 10, CLASSIC 20 and CLASSIC 30 models are fitted with a solid front panel without fabric when
delivered from our factory. If you wish, you can exchange this panel for the panel covered in fabric that is
also enclosed with your loudspeaker to suit your tastes. To do so, simply use your fingers to carefully lift off the
fitted panel.
Please ensure that you do not touch the drivers when doing so.
Once you have removed
the panel, place the fabric-covered panel in its position and softly push it in into place until it is flush with
the loudspeaker cabinet. You do not need to worry about any limitations or loss of sound details when using
either of the panels.
If you want to increase the sound quality even more in terms of precision and
bass response, try out our high-quality VC feet (for example VCF II M8 in the
image on the right) on your loudspeakers. The “Vibration Control“ feet are not
only an alternative to spikes for high-quality flooring, but also reduce the
transmission of vibrations between the loudspeakers and the floor. The result
is an audible improvement in the level of detail and realistic sound reproduction.
16
English |
Deutsch
CLASSIC Line
Correct: In order to correctly
unpack the loudspeaker, the top of
the loudspeaker should be facing
down. This means that you will
easily be able to hold on to the
bottom of the loudspeakers when
carefully pulling them out of
the box and also enables you to
attach the spikes without difficulty.
False: If the top of the
loudspeaker is facing up,
you will have to turn the
loudspeaker upside down
once you have removed it
from the box in order to
attach the spikes.
