Connections
Please ensure that the DAC1.1x Signature and any source equipment is switched off
before making any connections.
NOTE: It is important that all connections are firm, secure and airtight; any
oxidisation of the interconnects will result in loss of performance. Always use high
quality interconnects; Audio Note interconnects are recommended, as they are
manufactured to the same exacting standards as all of our products.
Inputs
The DAC1.1x Signature provides two digital inputs; a 75 ? RCA unbalanced input
and a 110 ? XLR balanced input. Optical inputs are not provided as we have found
optical transmission to sound far inferior to transmission via a standard coaxial cable.
Connect either the unbalanced or balanced input to your CD transport or other digital
source and ensure the input selection switch is in the correct position.
Outputs
The DAC1.1x Signature has one unbalanced analogue output. This consists of a stereo
pair of RCA connectors, colour-coded red for right channel and white for left channel.
Connect the output to a suitable pre-amplifier.
Ground Connection
In the unlikely event that a ground loop occurs, a ground post is provided for
connection to the ground post on your pre-amplifier. If you experience hum from the
DAC1.1x Signature after all connections are made and the unit is working, then try
out the following:
First, use a short piece of hook-up wire to electrically connect the ground post on the
DAC1.1x Signature to the ground post on the pre-amplifier, if this does not stop the
hum try connecting the wire to the CD-transport if it has a ground post. If not, then
put the bare wire to one of the chassis screws on the transport, if the hum persists,
contact your dealer for advice.
Mains Power
An IEC power connector is located on the back of the DAC. Use the supplied power
cable to connect the DAC1.1x Signature to the mains supply. Ensure the power is off
at the switch when you do this.