VSS-401-x Installation and Operation Manual
Document # 540335, Rev IR, 10/2006
Page 6 of 21
2.2.2 Sequence Select Mode
Using a single momentary switch, each of the video sources is routed to
the monitor, up to the number of video sources as configured by DIP
switches 3 and 4. Each time the sequence select switch is activated and
released, the next highest video source is selected. Upon reaching the
highest-numbered source, the next selection “wraps around” to the lowest.
Optionally, a briefer activate switch causes the previous source to the
routed to the monitor. Optional status LEDs provide a visual indication of
the currently selected source. The status pin will sink sufficient current to
drive a standard LED.
