Screen Excellence Ltd. 136 Bentwaters Parks, Rendlesham, Suffolk, IP12 2TW, UK Version 1.0 Mar
4
Fitting speakers to an interior wall
After finding the ideal speaker location required (not covered in this publication – maybe we should
say which publication?).
Using the electrical cable and pipe detector, scan the area immediately around the speaker location.
If no audible warning is indicated, it is then safe to proceed with the installation.
If drilling into a block or brick wall, it is recommended to use the minimum required safety
equipment, such as safety goggles and a dust mask.
Set the electrical drill to hammer action and
proceed to drill to a depth of approximately 30mm with
the 5.5mm masonry bit. The rawlplug (supplied) is inserted into the opening.
As illustrated below, place a screw and washer into the left opening of the wall bracket. After
partially tightening, place the small spirit level on top of the bracket, the location of the second screw
hole can then be marked. The bracket can be moved slightly to allow drilling and fitting of the second
screw. Finally, again using the spirit level, adjust the bracket to the optimum position (illustrated
below). All screws can subsequently be fully tightened.
