2
7
Important Note
Stereo
Mode
IMPORTANT
NOTE
ATTENTION:
This unit must be protected from damp because of the risk of fire and the
possibility of electric shocks.
1. Make sure that you have the correct mains voltage. Only operate the unit at the mains
voltage marked on the rear panel.
2. Make sure that nothing especially no metal objects are inserted into the device. This
could result in electric shock or malfunction.
3. If the unit is subjected to extreme fluctuations of temperature e.g. On being transported
from outside into a heated room, condensation can form. This unit should not be used untill
it has reached room temperature.
4. In the event of water or any other fluid being accidentally spilt on the unit switch the
unit off immediately and send it to a qualified service workshop for inspection.
5. Make sure that the unit is always well ventilated and never exposed to direct sunlight
6. Do not use sprays to clean the unit as they have a detrimental effect on the unit and could
ignite suddenly.
7. The machine use single power switch, please cut off the power before fix.
8. Please do not put the cup, vessel of flower or container above the machine, in case the
leak out water then cause the leakage current off the machine.
WARNING NOTICES
SAFEGUARDS
Electrical energy can perform many useful funtions, This unit has been engineered and
manufactured to assure your personal safety. Imporoper use can result in potential electrical
shock or fire hazards. In order not to defeat the safeguards, observe the following precautions
for its installation, use and servicing.
Explanation of Graphical Symbols
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
RISK OF ELECTRIC SHOCK
:
OPEN ONLY IF QUALIFIED
AS SERVICE PERSONNEL
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE
Before setting the mode, please turn off the amplifier and slide the
mode select switch to below (Picture 1). In this mode, Channel 1
an Channel 2 operate independently (Just traditional stereo
amplifier). The signal input into channel 1 can be output from
channel 1 only, similarly, the signal input into channel 2 can be
output from channel 2 only. The many channels, one by one in
order type pushes.
(
Picture1
)
Bridge
Mode
Before setting the mode, please turn off the amplifier and slide the
mode select switch to above (Picture 2), channel 1 and channel 2
are bridged, channel 3 and channel 4 are bridged. At time, the
signal input into channel 1 and channel 3 will be output from the
bridge end. On other hand, the output level control of channel 2
and channel 4 should be turn down to smallest. Only the volume
control of channel 1 and channel 3 are used to control the volume
of whole system.
(
Picture2
)
Output
Mode
