background image

   

3

DC-40615.01 

www.AudioEnhancement.com • 800.383.9362

Bluetooth Pairing

 

Press the 

power/MODE

 button to activate the 

Bluetooth

 function. 

Press the 

power/MODE

 button again to turn the 

Bluetooth 

f

unction off.

When the 

Bluetooth

 function is activated successfully, the screen 

will show “Bluetooth Disconnected”, then it is 

ready to pair.
Activate the 

Bluetooth

 connection on any 

Bluetooth

 capable device.

Find the device name “TQ8” on the pairing list 

to connect the device. 
When the paring is successful, it will emit a prompt tone and the 

screen will show “Connected.”
The speaker is ready to stream audio from the device. 
  

Make sure the power cable is unplugged and the power switch is in the 

off position before changing out the batteries. Only replace with 

batteries that are the same size and rating as the originals (12V - 2.8 AH 

Sealed Lead Acid). 

Battery Replacement

 

On the back of the XD Solo, you will see a 

large black plate. Remove the 4 screws 

around the edge of the plate. 
Once you remove the plate, carefully pull 

the batteries out far enough to reach the 

wires. Notice that wires are color coded red 

for the Po) terminal and black for the 

Negative(-). Carefully pulling on the wire 

clip, detach the wires from one battery and 

reattach to the same terminals on the 

replacement battery. Repeat this step for 

the next battery. This is easiest with needle 

nose pliers.
When sliding the batteries back into the 

compartment, watch to make sure the wires 

do not pull away from the battery’s 

terminals. If this occurs, gently push the 

connector with a pair of pliers to get a 

tighter fit.
Although the replacement batteries are 

charged, it's still suggested to charge the 

XD Solo for at least 12 hours before use.

 

Note: A good tip to prolong the life of your batteries is to leave the XD 

Solo plugged into AC power when not in use. This will ensure you 

always have a fully charged unit and will prevent the batteries from 

self-discharging. The XD Solo has an overcharge circuit so leaving the 

unit plugged in will not hurt the batteries or the unit. 

Reviews: