46
Precautions for Installing the Infrared Receiver and Infrared Receiver/Amplifier
Infrared Receiver and Infrared Receiver/Amplifier will produce small amounts of heat . Provide
a minimum of 10 cm (4 in .) when installing the amplifier close to the ceiling or wall . Infrared
Receiver and Infrared Receiver/Amplifier are for indoor use only . They cannot be installed and
used in any of the situations below:
• In a place where they can get wet
• Where chemicals are used including under the eaves (ex . pool)
• Places that contain high amounts of steam, oil, or a flammable atmosphere
• Places where radiation, such as X-ray, high radio waves or magnetism are present
• On the ocean, beach or near hot springs (where corrosive gases would be present)
• In a place where high levels of vibration are present such as on a vehicle, or marine vessel
When using the provided bracket, note the following points:
• Select a sturdy wall to install
• Ensure that the appropriate fasteners or screws are used, and that they are rated appropriately
for the load they will be required to carry
• Ensure that all the directions from the manufacturer of the anchor, fastener or screws are
followed
• Do a visual check and make sure that nothing is unsteady and the screws are tight
Note the following points when tightening bolts and screws:
• Proper torque must be applied to all bolts and screws
• A torque wrench or a torque driver are required to set the proper torque
• It is difficult to get the proper torque with an impact driver or electric driver even if it has a
clutch; therefore, they should not be used as they may damage parts for installation
Note the following points when installing the Ultimate IISE Infrared Receiver/Amplifier into
a rack:
• When mounting to a rack, remove the rubber feet from the base of the unit
• When installing near other heat-sensitive equipment, install the other equipment lower
than the receiver/amplifier system
• Install rack in such a manner as to provide for sufficient airflow to maintain a temperature
of no more than 40 °C (104 °F) in the rack
Precautions for Installation
More than
10cm (4 in.)
More
than
10cm
More
than
10cm
Front
side
