Audio Electronic Supply Six Pac's, Operation Manual, Page: 2 / 9

Specifications for your new SIX PAC’S power amplifier.
Operating the Six Pac’s power amplifier is a simple procedure. Each unit is designed for
long term stability in virtually any home operating situation. Please note, if the unit is
operated outside the parameters outlined in this owner's manual, damage may result.
Please read this manual carefully before putting your new Six Pac’s in operation. The
following definitions are applicable. Warnings should be followed explicitly.
1.2 Specifications
Specifications are subject to improvement without notice or obligation.
DIMENSIONS: 8’’H x 8’’W x 12.5’’D (20.3 cm x 20.3 cm x 31.75 cm)
WEIGHT: 33 lbs. (15 kg.)
CIRCUIT TYPE: Push-Pull, Triode, Class A/AB
POWER OUTPUT: 50 Watts RMS, 110 Watts IHF
INPUT SENSITIVITY: 1.2 volts for 50-Watt output
INPUT IMPEDANCE: 150,000 ohms
NOISE AND HUM: > 80db below full power
FREQUENCY RESPONSE: 15Hz to 23kHz at 50-Watts output
TUBES: 12BZ7 Input gain/phase inverter (12AX7 or 12AY7 may be used)
EL-84(6BQ5) current source for 12BZ7
6- EL-34(6CA7) output tubes
POWER TRANSFORMER: 1- EI laminated, 200% duty cycle
OUTPUT TRANSFORMERS: 2-EI laminated stereo (1-EI mono) Silicon Impregnated
RESISTORS: 1.0 % tolerance, precision metal film resistors
CAPACITORS: Polypropylene
AC CORD: 3 conductor shielded detachable
AC POWER REQUIREMENTS: 117/234 volts AC 50/60Hz
AC POWER CONSUMPTION: 200 Watts
WARM-UP TIME: 3 minutes
BREAK-IN PERIOD: 100 hours of music playing time
FINISH: Black Textured Steel Chassis
FRONT PANEL: Machined, Black Anodized aluminum
WARNING
HAZARD PRESENTS PERSONAL INJURY OR DEATH
Caution
EQUIPMENT DAMAGE MAY OCCUR BUT NOT PERSONAL INJURY
Note
Proper performance of the amplifier cannot be ensured
if disregarded