24
ENGLISH
The input sensitivity of the High Level Input is set to 15 ~ 45 V ex factory. If necessary, the input sensitivity for
each input channel can be changed to 2 ~ 15 V. To do this, you have to remove the respective jumper inside
the housing on the circuit board. Proceed as follows:
First disconnect the device from the power supply. Then remove the housing cover and locate the six jumpers
on the circuit board. These are located below the audio inputs.
Then carefully remove the jumper on the desired input channel to set it to an input sensitivity of 2 ~ 15 V. Use
suitable pliers for this.
HIGH LEVEL INPUT SENSITIVITY
IN CH7
IN CH8
IN CH5
IN CH6
IN CH3
IN CH4
IN CH1
IN CH2
Summary of Contents for ESX Quantum QL812SP
Page 30: ...30 NOTES...
Page 31: ...31 NOTES...
