8. After entering settings for all four inputs, pressing "Select" again moves to display
brightness setting mode. The display will alternately flash "Lo" and an arrangement of horizontal
and vertical lines. In this case, "Lo" is the display brightness in their dimmed condition, and "Hi"
is when they arc in their bright condition. Use the "Volume v" and "Volume ^" keys while
watching the displays to set the desired brightness. Use the "Mute" key to enter the settings.
9. Repeat the above process for the "Hi" condition. Press "Mute" again.
10. The display will indicate "End?" Press "Mute" if you are done, and your DLC will to enter
the operate mode. If you wish to go back and change any setting, press "Select" to go back to the
display selection mode.
Your DLC is now custom programmed and ready to provide you with years of superior
performance.
Enjoy!
Program Clearing
Should you have any trouble programming your DLC, or wish for some reason to simply have
the unit returned to the factory default settings, this can easily be accomplished:
1.
Remove power from the DLC and disconnect all connections.
2.
Remove the five Philips screws on the back channel.
3.
Pull the chassis cover back to expose the printed circuit board.
4.
Referring to the drawing below, locate the two jumper pins labeled J5.
5.
Short the pins together with the end of your screwdriver or other metal object while
applying power. Remove your screwdriver after 5 seconds.
