SABLE BATTERIES and the AMPLIFIER UNIT
4 use two 12VDC 10AH rechargeable sealed maintenance-free lead-acid batteries,
cated at the bottom of the unit. The life span of these rechargeable batteries is
nes of charging and discharging cycles.
) rechargeable batteries, lay the AWP6404
pside down. Remove the battery chamber
id the r echar geable battery, 34, will be
her the battery chamber cover is removed,
AW P6404 t o be r ightside up and the
battery will slide out. There are two cables
k) connecting to the poles of the battery.
)ole is color-coded red while the negative
3oded black. Remove the original battery
that with a new 12 VDC 10AH seal ed
-free rechargeable battery. T he positive
ter y needs to be connected to the red
r negative pole of the battery needs to be connected to the black cable. Make
connection is secure and firm. Slide the battery back into the battery chamber.
tery chamber cover back to its place and fasten with the original screws (x3).
lbattery chambers. Remove and replace the second rechargeable battery in the
:rhamber with the same procedures as above.
)cedures need to be done only when the installed rechargeable batteries become
need to be replaced. D ur i ng the normal use, do not remove any of the battery
rrs.
e battery chamber covers, there is a 1 3/8" (35mm) internal speaker mounting
licated by numeral 34.
- • • , - , • k • 101
/
-
1
(
)
.
t
M
H
Z
1TED SENSITIVITY (FM)
< 5 11 V
HATE FREQ. REJECTION (FM)
> 50 dB
S' RANGE
522 - 1,620 KHz
-:NCY (AM)
450 KHz
ITED SENSITIVITY (AM)
< 100 1.1V
HATE FREQ. REJECTION (AM)
> 50 dB
> 55 dB
EQUENCY RESPONSE
20 - 20,000 Hz
;FORM FILTER
16 Bit
,
I
I
C
S
H
O
C
K
P
R
O
O
F
45 Seconds
= 5 =
34
RECHARGEABL
E BATTER Y
RECHARGEABLE BATTER Y
CHAMBER COVER (bottom)
35
1 3,8" INTERNAL SPEAKER MOUNTING TOP HAT
e
36
HEADSET
MICROPHONE
38
DV battery Chamber
37
Belt pack
Clip
Headset M icr ophone L a v a l i e r e wireless tr ansm itter
36. HEADSET MICROPHONE
37. BELT-PACK CLIP
38. 9V BATTERY COMPARTMENT
39. POWER ON/OFF SWITCH --- Push the power On/Off switch in the direction
away from the red LED light to turn on the belt-pack wireless transmitter.
Push the power On/Off switch in the opposite direction to turn off the
belt-pack wireless transmitter.
40. POWER LED --- The red power LED light will be on whenever the power of
the belt-pack wireless transmitter is turned on.
41. LAVALIERE (LAPEL) MICROPHONE
42. MIC JACK --- This is a 3.5mm condenser microphone input jack.
43. VOL --- This is a microphone volume control knob for the microphone input
as indicated by the numeral 30.
HANDHELD WIRELESS MICROPHONE
49
46
9
V
BATTERY
44
ST EEL-MESH G RI LLE P O W E R ON/OFF
4
7
MI CRO PHO NE
S
W
I
T
C H
9
V
BATTERY
W I NDSCREEN4
5
C
O
M
P
A
R
M E NT
POW L E D
4
8
HO DE R
44. STEEL-MESH GRILLE MICROPHONE
WINDSCREEN
45. POWER LED --- The red power LED
light will be on whenever the power of
the handheld wireless microphone is
turned on.
= 6 =
H andhel d W ireless M i cr ophone
Lavaliere wireless MIC
50
BATTERY CO VER
Close
Open
42 MC jack
46. POWER ON/OFF SWITCH
47. 9V BATTERY COMPARTMENT
48. HOLDER
49. 9V BATTERY
50. BATTERY COVER
