Dante-MY16-AUD2 User Guide
Copyright © 2016 Audinate Pty Ltd. All rights reserved.
-15-
Connectors and Indicators
1. Primary RJ45 Gigabit Ethernet connector
Always used.
2. Secondary RJ45 Gigabit Ethernet connector for use when glitch-free redundancy or daisy chaining is
required.
See the 'Connection Examples' section for more information on setting up redundant and daisy-
chained networks.
3. Link status / activity LED
Green indicates an established link; flashing indicates link activity.
4. Gigabit link status LED
Orange indicates an established Gigabit Ethernet link.
5. Serial port
For Yamaha HA Remote. Requires a straight-through DB9 (DE9) serial cable with a male connector.
6. Status LEDs
The status LEDs indicate the following conditions:
n
System – Indicates the status of the Dante system on this card.
A Green light indicates the system is operating properly.
/
An amber or red light indicates that the system has failed to boot correctly.
n
Sync – Indicates the synchronization status of the Dante device.
A solid green light indicates that the device is a network slave and is synchronized to the
network master.
A flashing green light indicates that the device is the network clock master.
An orange light indicates the syncing is in progress.
A red light indicates a network synchronization error. Obtaining network sync may take up to 45
seconds.
n
Serial – indicates Rx and Tx activity via either the external or HA remote serial port
n
Error – Indicates Dante-host equipment synchronization state or network issues.
