Page 2
Page 9
Installation
In order to use the product securely and properly, please read the
manual before using and follow the instructions strictly to prevent
personal safety trouble and product damage caused by misuse.
Take care of the product, check the possibility of the product damage
caused by transportation and check all the listed items are present upon
receipt of the product:
LED Spot Light
1
Use Manual
1
Power cable 1
Handle
2
1. Make sure there is no flammable or explosive subjects within min 1.5
meter nearby the installation, the distance between wall and the light
shall be min 0.5M
2.Before installation, please check and make sure the power supply
voltage meet request of the system.
3. Please check ventilation and fans or exhaust passages are cleared.
4. The equipment should be fixed firmly.
5. For security reasons, the appliance must be earthed.
Inspection
1
2
3
4
5
6
7
Fault checking and repair)
No.
Fault description
Fault Checking
Not work,no light
output and the
fan doesn't work
1.Check power connection and see if the fuse is OK
2.Check if voltage value is in the normal range
3.Check power switch and disply screen on or off
DMX no control
1.DMX signal light must be on, if not, to check the
connection
2. If DMX signal light is on, but no reaction to the
channel, to check if the address code setting is correct?
3.If DMX signal is discontinuous, please check if
CANNON cable connect well?
4.Please Change to another DMX controller
5.Please Check if DMX signal cable is too close the
high-tension busbar which will damage or interrput the
signal output
One of channel
blocked
1.Be sure no DMX signal received
2.Please Check sound control is on and sensitivity is on
the right range
2.Driving circuit of motor might be damaged
Light sources work
discontinuously
1.Please check if input voltage is too high or too low?
2.The inner temperature is probably too high, change
a new fan if necessary
Can't be controlled
by Sound
1.Be sure no DMX signal received
3.Please Check if mic is damaged
4.Please Check if the light is on "HOLD" situation.
Horizontal
synchronous belt
damaged
1.Power off
2.Unscrewing screws of outer case and open the base
case
3.Unscrewing screws which are connect base case to
nose-arm parts
4.Loose all of the connecting cables
5.Please change new synchronous belt and installed it
on the gear shaft and the motor driving wheel
(Attention: the belt can't be too tight in case broken
6.Please Connect all cables
7.Tighten all the screws
1. Switch off power
2.Unscrew screws of outer shell of arm parts and take
off the outer case
3.Loose the screws of y-axis' motor driven board
4.Please Change to new synchronous belt
(Attention: the belt can't be too tight in case broken)
5.Tighten all the screws
Vertical synchronous
belt damaged
540
200
Part description
Light emitting
Thermovent
Function button
Thermovent
