Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.2.6
Hood Lock Cables, Adjusting
Procedure
When operating the release lever, the left and right lid locks must
be operated at the same time.
– Bring the left and right lid lock into the “closed“ position:
• The actuating links must allow the lock mechanisms on the lid
locks to engage up to the stop.
• Actuating links -1- and -2- must then be relieved.
– Turn adjuster -3- on the respective actuating link accordingly
-arrows- if necessary.
1.3
Rear Lid - Coupe
⇒ “1.3.1 Rear Lid, Gap Dimensions“, page 18
1.3.1
Rear Lid, Gap Dimensions
Special tools and workshop equipment required
♦ Adjusting gauge -3371-
Gap Dimensions
The gap dimensions can be checked with the Adjustment Gauge
-3371- .
• In -A- area = 4.5 mm +/- 0.5 mm
• In -B- area = 3.5 mm +/- 0.5 mm
• In -C- area = 4.0 mm +/- 0.5 mm
• In -D- area = 2.0 mm +/- 0.5 mm
• In -E- area = 2.0 mm +/- 0.5 mm
Gap Dimensions
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
18
Rep. Gr.55 - Hood, Lids
