Audi Q5 2008, Repair Manual

Page: 27 / 197

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
• It must be possible to move the selector lever out of “P” without
“getting stuck” when the locking button in the selector lever
handle is pressed.
– Turn off the ignition.
• It should not be possible to remove the ignition key when the
selector lever is in any other position than “P”.
– Move the selector lever into “P”.
– Remove the key.
• It should be possible to remove the key only when the selector
lever is in “P”.
• The selector lever does not move out of “P” even though both
the locking button and the brake pedal are pressed.
If the ignition key lock does not work as described, then perform
“Guided Fault Finding” using the Vehicle Diagnostic Tester .
3. Check the Closing Locks - Vehicles without an Ignition Key
Lock
– Press the Access/Start Authorization Button - E408- briefly to
get “ignition on”.
– Do not move the selector lever into “P” but rather, for example,
into “N”.
– Turn off the ignition.
• A warning message must appear in the instrument cluster.
• The vehicle cannot be locked.
– Turn on the ignition, shift the selector lever into the “P” position.
– Turn off the ignition.
• The vehicle can be locked.
If the specified values are not obtained:
– Perform
Guided Fault Finding
using the Vehicle Diagnos‐
tic Tester .
– Adjust the selector lever cable. Refer to
⇒ “1.11 Selector Lever Cable, Checking and Adjusting”, page
47 .
– Locking button on selector lever handle, checking. Refer to
⇒ page 23 .
4. Check Locking Button in the Selector Lever Handle
Make sure locking button moves easily.
• It must be possible to press the locking button without using
great force.
• After releasing, the locking button must come all the way back
out by itself.
– Check the selector lever handle for correct installation if the
specified values are not reached. Refer to
⇒ “1.8 Selector Lever Handle, Removing and Installing”, page
34 .
– Check if the selector rod or selector lever is bent.
Function Test
• The ignition is switched on.
Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
1. Selector Mechanism
23