Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pull oil filter element -3- and O-ring -2- out of sealing cap -1-.
– Clean sealing surfaces of sealing cap -1-.
– Lightly lubricate new O-rings -2- and -4- with engine oil and
insert O-rings.
– Fit new oil filter element -3- in sealing cap.
– Screw sealing cap -1- into oil filter housing and tighten it to
specified torque using socket (32 mm) (see table of tightening
Continue installation in reverse sequence.
3.43.6
12-cyl. petrol engine 6.3 ltr. FSI
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1331- , measuring range 6 to 50 Nm
♦ Or: torque wrench - VAS 6583- , measuring range 3 to 60 Nm
♦ Or: torque wrench - VAS 5820- , measuring range 20 to 100
Nm
Table of tightening torques for installation:
Component/fastener
[Nm]
Sealing cap
25
Requirements:
• Engine oil drained.
Procedure:
– Loosen sealing cap -arrow- using socket (32 mm) and remove
it.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
3. Maintenance
75