Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.15
Tyres: checking tyre pressures and ad‐
justing if necessary
Note
The tyre valves must be sealed with valve caps. Otherwise, dirt
could enter the valve, which will then become blocked and will no
longer seal properly.
Front and rear axles
Spare wheel and temporary spare wheel
3.15.1
Front and rear axle
The tyre pressure specifications are listed on the sticker on the
inside of the driver's door.
Tyre sizes not listed: See Wheel/tyre guide for tyre pressure
specification ⇒ Wheel/Tyre Guide; Rep. gr. 44 ; Wheels, tyres,
vehicle geometry; Tyre pressures .
Procedure:
– Check tyre pressure of all tyres.
– If necessary, adjust to correct tyre pressures.
Note
The tyre pressures listed only apply to cold tyres. When the tyres
are warm, the actual pressures will be higher, but must not be
reduced.
3.15.2
Spare wheel and temporary spare
wheel
The following parameters apply to the tyre pressure specifica‐
tions:
• Spare wheel with standard-size tyre: Inflate to maximum tyre
pressure indicated on tyre pressure sticker.
• Temporary spare wheel: The correct tyre pressure is indicated
on the sidewall.
Procedure:
– Check tyre pressure of spare wheel/temporary spare wheel.
– If necessary, adjust to correct tyre pressures.
Note
Depending on equipment version, there may only be a tyre repair
kit supplied; see Maintenance table.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
3. Maintenance
45
