Audi A8 2010, Maintenance Manual

Page: 32 / 142

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.5 Shipping mode: deactivating
WARNING
Risk of injury as engine of high-voltage vehicle can start un‐
expectedly!
♦ Observe warnings for high-voltage system:
♦ For work that must be performed with the ignition switched
on ⇒ page 11 .
Procedure:
– Connect vehicle diagnostic tester
⇒ page 20 .
– Select
Diagnosis
mode and begin diagnosis.
– Perform vehicle identification.
– De-select “Working with Guided Fault Finding” by removing
v
and press
Apply
.
– Switch to “Special functions” tab and select following program:
♦ 34 - Activating / deactivating shipping mode
– Start program by selecting
Carry out check
.
– Continue to follow instructions on screen.
Note
Deactivating shipping mode may cause the height of the vehicle
to drop.
3.6 Battery: reading out status and sending
diagnostic log
WARNING
Risk of injury as engine of high-voltage vehicle can start un‐
expectedly!
♦ Observe warnings for high-voltage system:
♦ For work that must be performed with the ignition switched
on ⇒ page 11 .
Battery -A- ⇒ page 28
Second battery -A1- ⇒ page 29
3.6.1 Battery -A-
Procedure:
– Connect vehicle diagnostic tester
⇒ page 20 .
– Select
Diagnosis
mode and begin diagnosis.
– Perform vehicle identification.
– Select “Working with Guided Fault Finding” by entering
v
and
press
Apply
.
– Switch to “Special functions” tab and select following program:
Audi A8 2010 ➤
Maintenance - Edition 11.2014
28
3. Maintenance