Audeze THE KING, Manual, Page: 10 / 16

Real-Time Metering
The front panel LED SPL meters are calibrated to show actual SPLs when
used with the LCD-4. The 75-segment LEDs display true SPLs from 90dB to
120dB. The last red LED segment warns of SPLs greater than 120dB. You
should NEVER see this red LED if you value your hearing!
1. 3-Pin XLR Connectors - XLR inputs are provided for balanced devices but
The King is wired for single-ended operation.
2. RCA Connectors - Main inputs, runs parallel to the XLR connectors.
3. Voltage Selector – Changes mains voltage from 110-120V AC to
220-240V AC depending on local line voltage.
4. Power Input – Standard three-prong IEC connector with line filter and fuse
drawer. For 110V use 1.6A slow blow fuse, for 220V use 1A slow blow fuse.
Connecting the King Headphone Amplifier
Connect the left and right source component output cables to the left
and right RCA or XLR analog inputs on the back of The King. XLR inputs
are provided for balanced devices but The King is internally wired for
single-ended operation and only the positive XLR input is active. The
negative XLR input is terminated to ground through a 22k ohm resistor.
Connect the AC power cord, and then your headphone to the standard
quarter-inch stereo output connector on the front panel. Be sure to keep
the volume low on first listen.
INPUTS INPUTS
BALANCED UNBALANCED
110 - 120 VAC, 50-60 Hz
220 - 240 VAC, 50-60 Hz
- L -
- R -
VOLTAGE
SELECTOR
POWER
CONSUMPTION
30W MAX
MADE IN CALIFORNIA, USA
T H E K I N G
HIGH RESOLUTION HEADPHONE AMPLIFIER
A-CLASS TUBE / MOSFET SINGLE-ENDED DESIGN
S E R I A L N U M B E R
CAUTION RISK OF ELE CTRIC SHOCK
NO US E R S E RVIC E ABL E PARTS INSID E
3 4 1 2
REAR PANEL