AUDAC WP2 Series, User Manual

Page: 10 / 16

WP2xx - User manual 010
Overview rear panel WP210
Rear panel description WP210
The rear of the WP210 contains an 8-pin Terminal Block connector, which is used to connect the wall panel to the
RJ45 connector. Below the 8-pin connector is a 6-pin connector. This input connector is a duplicate of the line and
mic input but for permanent connections. Below of the 6-pin connector are some DIP switches. These switches
allow certain functions to be turned on or off, depending on the situation the WP is in.
The rear of the WP210 contains an 8-pin Euro-Terminal Block connector, where the wall panel must be
connected to the RJ45 connector. For more information on how to make the connections can be found
under “Connecting” in Chapter 3 of this manual.
The 6-pin Euro-Terminal block is an input connector. This is a duplicate of the mic and line inputs but for a
permanent connection.
8-pin terminal block (3.81 mm pitch) output connection
6-pin terminal block (3.81 mm pitch) input connection
Terminal block output connection
Terminal block input connection
DIP switch mono / stereo for Line or Mic
DIP switch for Phantom power
DIP switch enable / disable output level +12 dBV