AUDAC HS208MK2, User & Installation Manual

Page: 7 / 12

7
The mounting bracket includes all parts as listed below. Make sure all these parts are
included with the delivery to ensure a safe and secure mounting of the loudspeaker.
- 1 x U-shaped metal bracket
- 1 x Left side L-shaped mounting ear
- 1 x Right side L-shaped mounting ear
- 1 x 75 cm steel drop safety wire with U-shackle
- 10 x M10x35 mm bolts with nuts + washer
Follow below steps for correct assembly method of the mounting bracket:
1) Mount both (left & right side) L-shaped mounting ears using the pre-drilled holes in
the speakers’ enclosure. Make sure the loudspeaker is positioned in the correct direction
(logo on the grill pointed to the bottom side) with the mounting ears on the bottom side
of the speakers’ enclosure holding the weight of the speaker (as shown in the explode
drawing). Fixation of these mounting ears is done using 6 x M10x35 mm bolts (three
on each side).
2) Fix the U-shaped metal bracket to the mounting position on the supporting structure
(ceiling or wall). The fasteners for fixation to the supporting structure are not included
and shall be chosen according to the surface. (wooden, concrete, brick, ... ). The fixation
shall be done by inserting fasteners through the base of the U-bracket and tightening.
Verify whether the fixation is sufficient strong once assembled before going to step 3.
3) Fix the speaker to the metal U-bracket by inserting two bolts through the center hole
of the U-bracket circular part and the L-shaped mounting ears. Tighten the bolts to
guarantee the speaker is fixed to the bracket.
4) Point the speaker into the desired direction, and insert two additional bolts through
the half circular groove. Once the perfect directional placement has been made, tighten
all the bolts for securing. Make sure the speaker has a minimum down-tilting angle
of 5° to avoid water and humidity flowing in, making it comply to the specified ingress
protection standards.
5) Attach the included drop safety steel wire to one of the provided mounting holes on
the speaker and fix the other side of the drop safety to any point which can structurally
support the weight of the speaker.