3
Installation
Make a hole with a diameter of 165mm. This is very easy when you use the carton that is inside of the
box.
Take the grille from the speaker and put the speaker in the hole.
Tighten the screws of the speaker so that the speaker will be clasped on the ceiling or wall.
Inside of the box, you can find gums. Put these gums on the sides of the grille. Then put the grille on
the speaker. The gums on the sides of the grille will prevent the grille from falling down.
Connections
Impedance
Connect the speaker according to the desired power, according to the following scheme.
Connect the power supply for the LED also according to the following scheme. Pay attention that
you don’t put power on the inputs of the speaker.
If you use different speakers in the same place, make sure that you use the same polarity for all the
speakers.
The total power of all connected speakers may not exceed the output power of the amplifier.
