11
CONVERT FOR USE IN LOW IMPEDANCE APPLICATIONS:
Warning:
Only perform this procedure if the speaker should be used in low
impedance applications.
For use in low impedance applications, the internal switches of the speaker must be
switched.
To reach the internal switches, the front cover plate with the AUDAC logo should be
removed very carefully. This is best done by carefully sticking a flat object under the
cover plate (e.g. a small flat screwdriver). The cover plate is coming loose, without
performing large forces.
After the cover plate is removed, the two power tap selector switches are visible.
To reach the internal switches, the plate with the two
power tap selector switches should be removed. This
can be done by loosening the 6 Phillips screws whereby
it is attached.
Once these screws are loose, the plate can be carefully
removed out of the speaker. (Be careful with the wiring
inside the speaker)
Then you will see that there are two switches provided
at the side of this plate. These switches are meant to
convert the speaker for use in 100V or low impedance
applications.
Set the switch to 100V for 100V applications, and set
the switch to 8
Ω
for low impedance applications.
Warning:
Make sure that the two switches are always both in the same position.
Make sure that it never occurs that one of them is on 100V and the other is in 8
Ω
position.
