16
16
16
16
Getting Started
APM:
When turning the power on, the APM paging station comes into its
“USER MODE”
. In this
mode you have function buttons (in most cases Zone buttons, 4-8-16), one “Select All” button,
one “Clear All” button and one “Talk” button.
When selecting a zone, the button will light up “green”. When pressing again, the green LED will
go out. You can select all Zones by pressing
“Select All”
and deselect all made settings by
pressing
“Clear All”
.
To make an announcement, you press the
“Talk”
button and keep it pressed down. This can only
be done in case the audio bus is free (=not in use by another paging Station. The yellow LED may
not light up).
Following actions will take place:
-
All selected zones will be transmitted to the ARU/AVD receive units and the relays will
switch.
-
Next step is the playing of the “gong” signal. During this, the “enable” LED flashes.
-
When the “gong” signal is terminated, the “enable” LED stops flashing, the “LOW” LED
lights up and the microphone is turned on. From that moment, the announcement can
begin. The best way to speak through the microphone is from a distance of ± 5 cm, and
with a voice level that makes the “green” LED (Level = GOOD) light up.
-
To terminate the announcement, just release the “Talk” button.
-
From that moment, you can change the selected zones for the next call.
The APM01 has just one “Talk” button, which is used to make a general announcement (All
zones). It’s also possible to specify a number of zones. This must be done in the Configuration
Manager Software Tool.
Chapter
2
