AUBER INSTRUMENTS
WWW.AUBERINS.COM
2019.07
P7/7
away from the heat from the smoker. Avoid exposing the controller under
directly sunshine during hot summer.
Figure 14. Two M4 screw holes on the back of the controller.
8. FAQ
8.1 Probe reading showing
“
-H-
”
.
This is the sensor input error message. It appears when the sensor is not
connected, sensor is bad or controller is bad. If you only see -H- error on one
probe, you can swap two probes to the different sockets (for example, plug in
pit probe to meat probe socket, and plug in meat probe to pit probe socket). If
this issue remains on the probe, your probe is bad. If this issue remains on the
controller, your controller is bad. For more details, please contact customer
support.
8.2 What if one step is set to end by food temperature while the food
probe is not plugged in?
If “
X-End
” of a certain step is set to “
Fd Temp
” while the food probe is not
plugged in, this step will never end.
(End)
Auber Instruments Inc.
5755 North Point Parkway, Suite 99,
Alpharetta, GA 30022
www.auberins.com
E-mail: [email protected] Tel: 770-569-8420
Copyright 2007-2019, Auber Instruments All Rights Reserved.
No part of this manual shall be copied, reproduced, or transmitted in any way without
the prior, written consent of Auber Instruments. Auber Instruments retains the exclusive
rights to all information included in this document.
