42
Get
ting R
ead
y
Attach the battery pack/battery cover (
▶
P. 37)
◎
Do not touch the terminal part of microSD memory card.
◎
Do not remove the microSD memory card forcefully. It
may result in damage to the microSD memory card or the
data loss.
◎
The microSD memory card may be warm after a long time
use. It is normal.
◎
Do not unmount a microSD memory card during saving.
Data may be damaged (erased).
Charging
When you purchase your product, the battery pack is not
fully charged. Make sure to charge the battery pack before
use. When the charging light in red turns off, charging is
complete.
◎
The product and the battery pack may become warm
while charging, depending on the situation, but this is not
abnormal.
◎
Charging while using camera etc. may take longer.
◎
For handling the battery pack, thoroughly read "Safety
Precautions" (
▶
P. 6) for proper use.
◎
When you operate the product with the specified charger
connected, the product may repeat short-time charging/
discharging resulting in short battery life.
◎
When temperature of environment or the product
becomes extremely high or low, charging may be
stopped. Try to charge the battery as far as possible at
room temperature.
◎
If the charging light blinks in red, check if the battery
pack is correctly attached or connected. Even if the light
keeps blinking, stop charging and then contact an au
shop or Secure cell phone support center.
◎
Clean the power terminal/charging terminal with dry
cotton swabs, etc. with care not to deform the terminals
every now and then. When they are dirty, the battery may
not be charged normally.
◎
Firmly close the external connection terminal cover after
charging to prevent water or dust from getting in. And do
not pull strongly or twist the cover.
◎
If charging is stopped while the charging light is still
turned on, the battery may not be fully charged even with
" " (Full) displayed. In that case, available time will be
short.
◎
When charging with Desktop Holder, do not use the
external connection terminal to charge. It does not
charge properly, and besides, it may cause a fault.
◎
Do not allow conductive foreign objects (metal fragments,
pencil leads, etc.) to come into contact with or get inside
the connection terminals.
