User manual
– SYSTOE
14 168
Rev. G
Page 14/38
Remove one double sided tape from its support pulling the tongue.
Apply the sticky part of the ring tape on the sensor.
8.4
Sensor and its cuff
Then, there are two cases according to the length of the toe: Normal toe
(§8.4.1) and Short toe (§ 8.4.2)
8.4.1 Normal toe
Stick the sensor on the extremity of the toe and fasten the sensor cuff.
The whole surface of the sensor must be well in contact with the toe.
The sensor must be placed on the back of the toe and not on the nail.
The sensor and its cuff must be positioned so that the sensor wire and the
cuff tube go downwards (as shown on the picture below).
Both cuffs must fit the toe but they must not be too tight. They must not
induce any residual pressure on the blood vessels.
The adhesive ring must not cover the
infrared cells
Remove the protective layer pulling
the tongue off
Press firmly all over the ring to make sure
it is well stuck on the sensor
