2.7.8 Suspend Type
The choices are “Stop Grant” and “PwrOn Suspend”.
2.7.10 Suspend Mode
Please refer to 2.7.5
2.7.11 HDD Power Down
Select “1-15 mins” to enable HDD Power Down mode between 1 to 15 mins. Select
“Disabled” to disable HDD Power Down function.
2.7.12 Soft-Off by PWR-BTTN
If you choose “Instant-Off”, then pushing the ATX soft power switch but- ton once will
switch the system to “system off” power mode. You can choose “Delay 4 sec”. If you
do, then pushing the button for more than 4 seconds will turn off the system, whereas
pushing the button momentarily
(for less than 4 seconds) will switch the system to “suspend” mode.
2.7.13 Wake-Up by PCI card
The choices are “Enabled” and “Disabled”.
2.7.14 PowerOn by Ring
Select “Enabled” to power on the system from a soft off state by an input signal on the
serial Ring Indicator (RI) line. The choices are “Enabled” and “Disabled”.
2.7.15 USB KB Wake-Up From S3
When “Enabled”, enter any key to wake up the system from S3 state. The choices are
“Enabled” and “Disabled”.
2.7.16 Resume by Alarm
When “Enabled”, set the date and time at which the RTC (real-time clock) alarm
awakens the system from suspend mode. The choices are “Enabled” and “Disabled”.
2.7.17 Primary IDE 0 (1) and Secondary IDE 0 (1)
When Enabled, the system will resume from suspend mode if Primary
IDE 0 (1) or Secondary IDE 0 (1) becomes active. The choices are
“Enabled” and “Disabled”.
2.7.18 FDD, COM, LPT PORT
When Enabled, the system will resume from suspend mode if the FDD, interface,
COM port, or LPT port is active. The choices are “Enabled” and “Disabled”.
2.7.19 PCI PIRQ [A-D]#
When Enabled, the system resumes from suspend mode if an interrupt occurs.
The choices are “Enabled” and “Disabled.
2-18
Chapter 2: BIOS setup
