Attonics Systems ATTO3, Manual, Page: 7 / 26

ATTO 3 Manual 1.6 7
Quick Startup Guide
1
Install the software located inside the flash-drive provided by Attonics.
Run the
attonicssetup1.X.X.exe using administrator privileges. Password for the
setup is “atto3”. In case of an error during auto-launch of Attoview.exe, please
ignore and open it manually from the installed location.
Tip: check the check box - place a shortcut on desktop
2
Launch the Attonics software AttoView.
3
Locate the USB cable provided with the spectrometer. Connect the USB type-A end
to the computer and USB type-micro B end to the Attonics spectrometer.
4
The software detects the device as soon as it is connected.
5
Once it is connected, all the features based on the spectrometer are activated.
6
You can capture the spectrum in the following modes:
1. Acquire Live
2. Acquire a Snap
3. Acquire Snap using HW trigger
7
Place your spectrometer bottom side up looking at any ceiling light. Click Snap
icon to get a single shot spectrum of the light source.
8
If you see a spectrum in the spectral window, you have now been initiated into the
black magic of spectroscopy. You are welcome! Go ahead and explore all the
features to make full use of our spectrometer.
Typical spectrum recorded by our spectrometer for a fluorescence lamp