■
Explanation of each parts (1)
・ EXTERNAL INPUT / OUTPUT (CON.)
It is possible to do the various outside output and
display reset from outside. For details, see the
explanation of the output connector page No.9.
・ POWER CONNECTOR (DC)
Insertion connector of AC adapter for the charging.
The standard recharging time is about 4 hours after making
a power off. The charging condition can be confirmed by
display when making a power on. Also, it can be used
inserting AC adapter. However, it becomes the cause which
hastens the degradation of the charging battery. Recommend
to use without using AC adapter as much as possible.
・ GAIN ADJUST DIAL
ONLY MANUFACTURE SIDE (NEVER CHANGE THIS DIAL)
It is used when the calibration at the manufacture.
・ LCD DISPLAY
Using graphic LCD (liquid crystal), it is possible to
show a feature character, setting character, numbers and
charging scale in the display.
・ PROTECTION GLASS
Digital display is covered by protection glass.
・ MODEL AND MAX. CAPACITY STICKER
Model number and maximum display value of 3 units and
indicated.
・ POWER SWITCH (P)
On/Off button of the power. The buzzer sounds in case
of start the operation.
・ DATA OUTPUT SWITCH (D)
Output button for the digimatic signal and RS-232C signal
of the data. It outputs a digital signal firstly and it
outputs a RS-232C signal.
(Caution)
It outputs the digital signal when using a function
feature. Also, in case of function feature (FU), it can be
changed Peak Hold and Tracking, the reading of memory data
and various setting of value.
－６－ ATTONIC
