ATTO Technology Diamond Array VT, Installation And Operation Manual

Page: 79 / 96

68
Hardware maintenance
Exhibit 10-2: Above, disk drive sled partially pulled out of the Diamond
Storage Array. Bottom left, top of disk drive sled. Bottom right, underside
of disk drive sled showing individual drives
Exhibit10-3: The Fibre Channel or SCSI Host
Interface C ard may be replaced by shutting
power dow n, removing any cable attached to the
port, removing the GBIC or SFP according to
manufacturer's instructions, loosening the
screws at the top and bottom of the card, then
carefully pulling out the unit.
Exhibit 10-4: A power supply pulled out from a rackmount Diamond Storage Array: do not leave an empty opening
while the Diamond Storage Array is operating. Access the blower assembly and the power supply by loosening the
screws on either side of the component, then pulling out the part. If a blower or power supply stops working, keep it
in place until another component is installed. (Note: host interface configuration pictured is not supported)