18 - GB
GB
NB:
Whenever the batteries are changed in the receiver, synchronisation must be repeated.
*If you did not manage to synchronise the remote control and the receiver during this time, remove the batteries and then put
them back. You can then repeat the synchronisation process.
SYNCHRONISATION OF THE REMOTE CONTROL AND RECEIVER
The remote control must now be synchronised using the wood-burning stove receiver. Procedure to synchronise the remote control
and receiver:
1.
Insert batteries in the receiver.
2.
The LED light in the front of the wood-burning stove should flash yellow and then light green. This means that the damper
is operating a start-up reference test. You may also hear a ‘click’ sound, which is completely normal. This process may take
up to two minutes.
3.
After the test is finished,
the LED light will flash red for 20 seconds
. During this time, the remote control and receiver are
synchronised*. First, press the ‘up’ button and then press the ‘down’ button.
4.
The LED light will briefly light green when the synchronisation is complete and then go out.
INSERTING BATTERIES IN THE REMOTE CONTROL
1.
First, insert new batteries in the remote control.
2.
The remote control must be in the manual setting for the remote control and the receiver to synchronise. If the remote
control is in the automatic setting, set it to manual by briefly pushing the ‘up’ and ‘down’ buttons at the same time.
Manual setting
Automatic setting
Down
Up