Shadow Tracker Micro Vision Installation Instructions
Between dash and glove box.
Connecting the Unit
The Micro Vision unit should be connected in the following order:
Plug in the GPS antenna
Connect/Verify the GSM antenna is connected
Plug in the Power harness
Verification
The Shadow Tracker Micro Vision unit has a 4 LED display on the front of the unit. When the
unit is initialized it will run through a startup sequence, following this sequence verify the status
of the following lights.
PWR
- power Led should be a solid Green
GPS
- GPS acquisition light should blink Green if parked stay solid Green when in motion (if
GPS Light stays red after 2-3 min, check antenna placement, and connection.)
Com
- Communication light should blink yellow once per minute while stopped and every ten
seconds while in motion. (If COM light is Red please call technical support).
Safety and Care
Please follow these guidelines to ensure the safe and trouble-free operation of your
Tracking Unit(s).
Safety
Do not place the Unit near a heating device.
Do not place the Unit in direct sunlight.
Do not place anything heavy on the Unit.
Do not place where spills can occur on the Unit.
Do not subject the Unit to electrical shock.
Do not apply any physical pressure to the Unit.
Do not open or disassemble the Unit or any of its components.
Do not scratch, twist or push the surface of the LED.
Only use the Antenna provided by ATTI®.
Care
Occasionally, the Tracking Units may need to be cleaned. Use the following precautions:
Cleaning
Use a soft cloth to wipe the exterior.
Do not use an alkaline detergent.
Do not use alcohol on the Unit case.
Avoid excessive moisture when cleaning the Unit.